DRIVER MODEL REFERENCE
Srixon ZXi LS · Driver
Srixon ZXi LS driver from Dunlop Sports’ US product page: 3 lofts (8°, 9°, 10.5°), 460 cc head, 45.75 in standard length.
- Published loft options
- 8, 9, 10.5°
- Published lie
- 59°
- Published length
- 45.75 in

Documented specifications & build options
Stock build and standard hosel setting from Dunlop Sports’ US specification table for Srixon; lengths in inches, swing and club weights as published per flex.
| Field | Documented value |
|---|---|
| Published loft options | 8, 9, 10.5 ° |
| Published lie | 59 ° |
| Published length | 45.75 in |
| Published head volume | 460 cc |
| Stock shaft | PROJECT X HZRDUS BLACK GEN 5 70/60 |
Source: Srixon ZXi LS driver US product page (Dunlop Sports US store). Reviewed 2026-10-22.
Specifications by configuration
| Configuration | Published values |
|---|---|
| 8.0° ↗ | Loft: 8 ° Lie: 59 ° Length: 45.75 in Head volume: 460 cc Handedness: RH Swing weight: D3.5 ( R, S), D4.5 (X) Club weight: 326g (X), 317g (S, R) |
| 9.0° ↗ | Loft: 9 ° Lie: 59 ° Length: 45.75 in Head volume: 460 cc Handedness: RH/LH Swing weight: D3.5 ( R, S), D4.5 (X) |
| 10.5° ↗ | Loft: 10.5 ° Lie: 59 ° Length: 45.75 in Head volume: 460 cc Handedness: RH Swing weight: D3.5 (R, S) |
Identifying the right model
- Two red-rimmed weight ports sit in a front-to-back line on the black sole with LS lettering between them; SRIXON runs across the centre, ZXi sits on the rear edge and 9.0 is marked beside the hosel.
What to check before using the reference
- Srixon’s page describes a 1.5-degree adjustable hosel sleeve for loft, lie and face angle and two adjustable sole weights placed front and rear for spin; the table gives the stock setting only.
- Only the 9.0° head is listed in both hands; 8.0° and 10.5° are right-hand only in the table.
- Srixon’s footnote says its published driver lengths now follow USGA and R&A measurement guidelines and read about ½ in longer than before without the club itself changing.
Checking a club you own? These are the maker's published figures for an original build, not measurements of your club, and a source date is not the year it was made. Bending, reshafting or a hosel adjustment changes loft, lie and length, so identify the head by its own markings and have a fitter measure it when its history is unclear.



